轧制变形对高强导线用Al-Mg-Si-Sr-B合金组织与导电性能的影响

    Effect of Rolling Deformation on Microstructure and Electrical Conductivity of Al-Mg-Si-Sr-B Alloy for High Strength Wire

    • 摘要: 对Al-Mg-Si-Sr-B合金进行不同变形量冷轧+160℃×4 h时效处理,采用OM、硬度测试、导电率测试等研究了冷轧变形对合金组织与性能的影响。结果表明:随着轧制变形量的增加,Al-Mg-Si-Sr-B合金的硬度逐渐提高,导电率先降低后升高。80%冷轧变形量的合金硬度达到最大值101.6 HV,其导电率为56.0% IACS。冷轧态合金经160℃×4 h时效处理后未发生再结晶,仍保留轧制态合金纤维状组织。80%冷轧变形量的合金组织中晶粒完全破碎,组织为纤维状组织。

       

      Abstract: The Al-Mg-Si-Sr-B alloy was cold-rolled with different deformation amount, then aged at 160℃×4 h.The effects of cold rolling deformation on the microstructure and properties of the alloy were studied by OM, hardness test and conductivity test.The results show that with the increase of rolling deformation amount, the hardness of Al-Mg-Si-Sr-B alloy increases gradually, and the conductivity decreases first and then increases.The hardness of 80% deformation amount cold-rolled alloy reaches the maximum value of 101.6 HV, and its conductivity is 56.0%IACS.The cold-rolled alloy does not undergo recrystallization after aging at 160 ℃×4 h, but still retains the rolled fibrous microstructure.When the rolling deformation amount reaches 80%, the grains of the alloy are completely broken and the microstructure is fibrous.

       

    /

    返回文章
    返回